Hall-Effect Based Current Transducers Handle up to 50A

LEM has launched six new current transducer series to their expansive portfolio. The new transducer families are; LXS, LXSR, LES, LESR, LKSR, LPSR. Each transducer can be mounted on printed circuit boards for non-intrusive and isolated measurements of dc, ac and pulsed nominal currents from 1.5A to 50A thanks to a multi-range configuration. These closed-loop current transducers are based on LEM's custom proprietary patented Hall Effect ASIC, providing performance at the level of fluxgate transducers.

The LxSR current transducer range has an offset drift that is over four times lower than the previous generation of closed-loop transducers based on Hall cells. The value reached is very similar to those using fluxgate, typically between 4 to 14 ppm/degree C.

LEM’s spinning technique and specialized integrated circuits (IC) have been significant contributors to these drastic improvements. With the products’ performance of fluxgate, customers are not only provided with better control and increased system efficiency, but also a significantly lower price.

Advanced manufacturing techniques have also been implemented with full automotive qualification in mind, allowing these new transducers to achieve the highest levels of quality and traceability. The LxSR production line has been designed to be autonomous, with an “Industry 4.0” approach.

Six families and 22 models are available with various options, such as an integrated reference (VREF), footprint (3 or 4 primary pins with different layouts), with an aperture and/or with integrated primary conductors. Overcurrent detection output is also available with theLPSR models on a dedicated pin, which indicates when a measured current is exceeding its expected value or to be used to safely switch power off in the event of a short circuit.

LXSR, LESR, LKSR, LPSR models operate from a single 5 V supply and provide their internal reference voltage to a VREF pin. An external voltage reference can also be driven between 0.5 and 2.75V.

This new series is also fully compatible with the previous LEM LTS/LTSR/CAS/CASR/CKSR series, by fitting in the same footprint with options for integrated primary jumpers or an open aperture. So, this new series can be easily retrofitted into existing installations while still offering various compact sizes and a variety of PCB mounting layouts, without compromising on the high insulation level provided between the primary and measurement circuits.

Their wide operating temperature range from -40 to +85 degrees C, and even up to +105 degrees C with the LES, LESR, LKSR, and LPSR series, also makes the series suitable for use in any industrial applications.

Applications such as variable speed drives, servo motor drives, uninterruptible and switch-mode power supplies, battery-supply installations, power supplies (welding), air conditioning, home appliances, static converters for dc motor drives, and robotics all integrate a higher number of transducers due to the high levels of control and automation that improve productivity and energy efficiency. In the search for the best efficiency at the best price, these applications benefit from the high-performance cost effective LXS, LXSR, LES, LESR, LKSR, LPSR series.

They will be particularly well suited to applications where low offset drift is important such as in the ac output of solar power installations, where standards require a very low dc component in the output current.

LXS, LXSR, LES, LESR, LKSR, LPSR series current transducers are CE marked and conform to the latest industrial standards, as well as being covered by LEM’s five-year warranty. These new products have gone beyond the preconceived limits of Hall effect technology to compete against fluxgate technology performance.