New Industry Products

Probes Measure High Frequency Motor Drive Common-Mode Currents

March 21, 2016 by Power Pulse1595211359

Motor installers and design engineers can deal more effectively with high frequency (HF) common-mode currents caused by variable-frequency drives, using the latest non-contact current probes announced by Power Electronic Measurements Ltd (PEM) at the Applied Power Electronics Conference (APEC 2016).

The new CMC series of current probes, using Rogowski technology, empower engineers to assess the magnitude of the threat posed by HF common-mode currents that can damage motor bearings and interfere with nearby electrical equipment. The current measurements can help determine suitable corrective action, such as fitting brushes, insulated bearings, or choke coils, and with further measurements assess the effectiveness of the chosen remedy.

The screened coils have excellent immunity to voltage disturbances and a low frequency (-3dB) bandwidth that attenuates unwanted 50/60Hz magnetic fields while maximizing the SNR of the measurement of the high frequency commode mode currents.

Available in coil sizes from 300 to 1000mm, and longer if required, making them suited for use with a wide range of motor shafts. Even with a coil circumference of 1000mm the CMC probes can achieve a high frequency (-3dB) >10MHz.

The probes are available in three sensitivity grades for measuring bearing currents up to 37.5A, 75A or 150A peak. The peak detected current corresponds to a maximum output voltage of ±7.5V when connected to an oscilloscope input via the BNC output provided.