Components

3A Half H-Bridge Driver for DC Brush Motors and Solenoids

The MP6610 from Monolithic Power Systems is an half-H-bridge driver, with current measurement and regulation features. It can operate from a supply voltage from 4V to 55V and can deliver up to 3A output current (depending on the package, PCB design, and ambient temperature).

The MP6610 can be used to drive solenoids, dc brush motors, or other loads. (See typical application diagram above).

An internal current sensing circuit delivers an output whose voltage is proportional to the load current. Likewise, cycle-by-cycle current regulation/limiting is provided. These features do not require the use of a low-ohm shunt resistor.

Internal diagnostic and protection features include open load detection, over-current protection, under-voltage lockout (UVLO), and thermal shutdown.

The MP6610 is available in 8-pin TSOT23 and SOIC packages. Note that due to the small pin spacing, the TSOT23 package is only recommended for use up to 45V, unless conformal coating or encapsulation is used.

It has a high-side on-resistance of 100mΩ and a low-side on-resistance of 128mΩ.

The driver features simple, versatile logic interfaces, and its inputs are compatible with 2.5V, 3.3V, and 5V logic.

Product Features
  • Wide 4V to 55V Input Voltage Range
  • 3A Maximum Output Current
  • Internal Half-H-Bridge Driver
  • Cycle-by-cycle Current Regulation / Limit
  • Low On-Resistance (HS: 100mΩ; LS: 128mΩ)
  • No Control Power Supply Required
  • Simple, Versatile Logic Interfaces
  • Inputs Compatible with 2.5V, 3.3V, and 5V Logic
  • Over-current Protection
  • Open-Load Detection
  • Thermal Shutdown
  • Under-voltage Lockout
  • Fault-Indication Output
  • Thermally Enhanced Package
Monolithic Power Systems Inc.
To Top

Join 50,000+ Power Pros

 

  • Keep pace with relentless innovation
  • Influence the conversation
  • Take your insights to another level

You have Successfully Subscribed!